Yamaha TT-R90(V) Owner's Service Manual page 312

FRONT WHEEL AND REAR WHEEL
2
1
5 - 9
Rear wheel
1. Install:
• Wheel bearing 1
• Spacer 2
• Wheel bearing 3
NOTE:
• Apply the lithium soap base grease on the oil
seal lip when installing.
• Use a socket that matches the outside diam-
eter of the race of the bearing.
• Right side of bearing shall be installed first.
CAUTION:
Do not strike the inner race of the bearing.
Contact should be made only with the outer
race.
2. Install:
• Drive chain 1
NOTE:
Push the wheel 2 forward and install the drive
chain.
3. Adjust:
• Drive chain slack
Refer to the "DRIVE CHAIN SLACK
ADJUSTMENT" section in the CHAPTER
3.
4. Install:
• Tension bar 1
• Bolt 2
• Nut 3
26 Nm (2.6 m · kg, 19 ft · lb)
• Cotter pin 4
New
CHAS