Table of Contents
Advertisement
FRONT FORK
21. Measure:
9 Distance a
Out of specification¡Turn into the locknut.
Distance
20 mm (0.79 in) or more
Between damper rod 1 1 top and
locknut 2 2 top.
22. Loosen:
9 Rebound damping adjuster 1
NOTE:
9 Loosen the rebound damping adjuster finger
tight.
9 Record the set position of the adjuster (the
amount of turning out the fully turned in posi-
tion).
23. Install:
9 Cushion rubber 1
9 Washer 2
9 Spacer 3
To cap bolt 4.
NOTE:
Install the cushion rubber with its smaller dia.end
a facing the cap bolt.
24. Install:
9 Push rod 1
9 Fork spring 2
NOTE:
9 Install the fork spring with the damper rod 3
pulled up.
9 Install the fork spring with its smaller pitch end
facing the cap bolt. (For EUROPE)
9 After installing the fork spring , hold the damper
rod end so that it will not go down.
25. Install:
9 Cap bolt 1
Fully tighten the cap bolt onto the damper
rod by hand.
5-36
CHAS
a a :
Advertisement
Table of Contents
