System connections (continued)
Make sure to unplug the AC power lead before making any connections.
The spec label (*)
21W
10
The spec label illustration
may be different from the
actual label used.
(*) Label is located at the
bottom of the unit.
Remote control - battery installation
Note:
Before using remote control, please remove plastic shield
at battery holder.
1
While pushing the locking tab towards the centre
of the remote control, slide out the battery holder.
Remote
control
Battery holder
2
Remove the old battery from the battery holder,
insert the new battery and then slide the battery
holder back into the remote control.
Battery holder
Polarity
(+) symbol
Battery type
Locking tab
FM aerial
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Back of remote
Plastic
shield
Locking tab
Positive (+)
side up
Precautions for battery use:
Remove the battery if the unit will not be used for long
periods of time. This will prevent potential damage due
to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium
●
battery, etc.).
control
Danger of explosion if battery is incorrectly replaced.
●
Replace only with the same or equivalent type.
●
Batteries (battery pack or battery installed) shall not
●
be exposed to excessive heat such as sunshine, fire
or the like.
Installing the battery incorrectly may cause the unit to
●
malfunction.
Notes concerning use:
Replace the battery if the operating distance is
●
reduced or if the operation becomes erratic. Purchase
"CR 2025", coin lithium battery.
Periodically clean the transmitter on the remote control
●
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
●
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
●
shock, and vibrations.
E-3
Left speaker
Right speaker