Setting Up Point-To-Point Protocol - IBM xSeries 330 Hardware Maintenance Manual

10. Press Esc to return to the Utility program main window.
11. Use the arrow keys to select Exit Utility from the menu or press Esc to close
12. Remove the CD from the CD-ROM drive. The Remote Supervisor Adapter
Continue with "Setting up point-to-point protocol" on page 74.

Setting up point-to-point protocol

The Remote Supervisor Adapter serial port supports point-to-point protocol (PPP).
The PPP enables TCP/IP communication over the serial port, which enables
Web-based management and TELNET sessions over a modem.
To set up PPP, complete the following steps:
74
Hardware Maintenance Manual: xSeries 330 Type 8675
Note: The values in the following window are only examples; your settings
will be different.
6. Verify the following serial port values:
Baud Rate
The default is 57600. Make sure that the baud rate matches the baud
rate of the device you are connecting to the serial port on the Remote
Supervisor Adapter.
Parity The default is None.
Stop Bits
The default is 1.
Note: The data bits value is preset to 8 and cannot be changed.
For detailed information about the serial port and modem settings, see the
IBM Remote Supervisor Adapter User's Guide for the xSeries 330.
7. If you make changes to the serial port settings, press F6 to apply the changes.
8. Press Esc to return to the Configuration Settings window.
9. If you need to set up PPP, go to "Setting up point-to-point protocol";
otherwise, continue with step 10.
the Utility program.
restarts automatically.