Table of Contents
Advertisement
11/05/07 10:12:23 32KVCC00_086
1.
Place a drain pan under the crankcase.
2.
To drain the oil, remove the oil fill cap/
dipstick, oil drain bolt ( ), and sealing
washer ( ).
2
(2)
(1) Oil drain bolt
(2) Sealing washer
76
3.
Check that the sealing washer on the
drain bolt is in good condition and install
1
the bolt. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
Engine oil drain bolt torque:
30 N·m (3.0 kgf·m , 22 lbf·ft)
4.
Fill the crankcase with the recommended
grade oil; approximately:
0.8 (0.8 US qt , 0.7 Imp qt)
5.
Install the oil fill cap/dipstick.
6.
Start the engine and let it idle for 3 5
minutes.
7.
2 3 minutes after stopping the engine,
check that the oil level is at the upper
level mark on the oil fill cap/dipstick with
the motorcycle upright on firm, level
ground. Make sure there are no oil leaks.
(1)
Hide quick links:
Advertisement
Table of Contents
