HP R1500 - UPS XR User Manual page 33

Enter the host name of the UPS Network Module in the Hostname field. The host name is the first part
d.
of the fully qualified domain name used by the DNS. The host name is sent to the DNS only if the
DHCP server sends the host name with the new IP address. The default value of the two parameters
comprising the fully qualified domain name is ups.domain.com.
Enter the name of the domain to which the UPS Network Module belongs in the Domain Name field.
e.
The domain name is the part of the fully qualified domain name that follows the host name and is
used by the DNS. The default value of the two parameters comprising the fully qualified domain
name is ups.domain.com.
Select or clear the IPv6 Enabled checkbox to enable or disable IPv6, respectively. The local IP address
3.
of the UPS Network Module is built from the MAC address and appears in the IPv6 Local Address field
when IPv6 is enabled.
If IPv6 is enabled, select the IPv6 Auto Config Enabled checkbox to have the IPv6 router build the IPv6
4.
Address 1, Prefix length, and IPv6 Address 2. The IPv6 Gateway field is empty and cannot be edited.
-or-
Clear the IPv6 Auto Config Enabled checkbox and enter the following settings:
IPv6 Address 1—Set a static IPv6 address.
o
Prefix length—Set a prefix for the IPv6 Address 1.
o
IPv6 Gateway—Set the default gateway.
o
Select Enabled from the Firmware Upload to allow remote upgrade of the UPS Network Module
5.
firmware through the network. If this option is disabled, remote firmware upgrade is not allowed.
Enter the IP address of the DNS server that normally provides the translation of the domain name to IP
6.
address in the Primary DNS Server field.
Enter the IP address of the secondary DNS server that provides the translation of the domain name to IP
7.
address when the primary DNS server is not available in the Secondary DNS Server field.
Enter the host name or IP address of the SMTP server used to transfer email messages in the SMTP Server
8.
field.
Select the SMTP server authentication checkbox to require a user name and a password for SNMP
9.
authentication. Enter the user name in the Login field, and then enter the password in the Password field.
NOTE: The UPS Network Module will not send email notifications until the recipients are
configured on the Email Notification screen (on page 44).
Click Save.
10.
For your changes to take effect, be sure to reboot the UPS Network Module by clicking Reset
11.
Communication on the System Settings screen (on page 30).
Click Help to view online help.
HP UPS Network Module web interface 33