Configuring Dynamic Routing - Cisco Small Business RV315W Administration Manual

Networking
Configuring Routing
STEP 4
STEP 1
STEP 2
STEP 3
Cisco RV315W Broadband Wireless VPN Router Administration Guide
- Interface: Use a WAN interface as the next hop.
- Disable this rule if the interface is down: Check to disable this rule
when the selected WAN interface is down.
Click Save to save your settings.

Configuring Dynamic Routing

Dynamic routing is an Interior Gateway Protocol (IGP) that is commonly used in
internal networks. It allows a router to exchange its routing information
automatically with other routers, and allows it to dynamically adjust its routing
tables and adapt to changes in the network.
Dynamic routing enables the RV315W to automatically adjust to physical changes
in the network's layout and exchange routing tables with the other routers.
The RV315W determines the network packets' route based on the fewest number
of hops between the source and the destination.
To configure dynamic routing:
Click Networking > Routing > RIP. The RIP page opens.
In the RIP Basic Settings area, enter the following information:
• RIP Status: Click Enable to enable RIP, or click Disable to disable it. By
default, RIP is disabled.
• RIP Version: Specify the RIP version. The RV315W supports RIPv1 and
RIPv2.
• RIP Timer: Enter the values for the RIP refresh time, RIP timeout, and Flush
time.
• RIP Advertisement By: Choose either an interface or a RIP network for
routing.
If you choose an interface for routing in the RIP Advertisement By area, specify
the RIP interface settings in the RIP Members area.
• Check Enable RIP to enable RIP on an interface.
• Click Edit to specify the following RIP settings for an interface:
- RIP: Displays whether RIP is enabled or disabled on this interface.
5
65