Repairing/Replacing Rear Wheel Tire/Tube; Handrim Replacement - Invacare A4 Owner's Operator And Maintenance Manual

Adjustable seat angle
Hide thumbs Also See for A4:
Table of Contents

Advertisement

WHEELS
HANDRIM REPLACEMENT (FIGURE 6)
1. Remove rear wheel from the wheelchair.
Tire MUST be deflated before any disassembly procedures are
performed.
2. Remove all air from the tire by pressing down on the pin in the center of the valve
stem.
3. While carefully holding the tire, bar and rim strip to one side, hold the phillips
screws and remove the locknuts that secure the handrim to the rear wheel.
4. Remove the existing handrim.
5. Install the new handrim by reversing the above procedures.
DO NOT inflate tire until it is completely assembled.
6. Inflate tire to correct psi rating on the sidewall of tire.
Make sure detent pin is fully released BEFORE operating the wheelchair.
7. Reinstall rear wheel to the wheelchair.
8. Repeat the procedure for the opposite rear wheel if necessary.
Handrim
FIGURE 6 - HANDRIM REPLACEMENT

REPAIRING/REPLACING REAR WHEEL TIRE/TUBE

Replacement of a pneumatic tire or tube MUST be performed by a
qualified technician.
Part No. 1110545
WARNING
WARNING
WARNING
Locknut
WARNING
47
Phillips
Screw
A4™AND A4™TITANIUM
SECTION 5

Advertisement

Table of Contents
loading

This manual is also suitable for:

A4 titanium

Table of Contents