Table of Contents
Advertisement
SECTION 7—FOOTREST/ANTI-TIPPER
Installing
1.
Install the two half clamps onto either side of the
wheelchair frame approximately 2‐inches (5.08 cm)
above existing footrest with two provided allen screws.
2.
Repeat for the opposite side of the wheelchair.
3.
Slide the clamp on raised footrest into the half clamps to
the desired height.
4.
Securely tighten the four allen screws.
Adjusting
1.
Loosen the four allen screws.
2.
Adjust clamp on raised footrest to the desired height.
3.
Securely tighten the four allen screws.
Replacing/Adjusting Optional Adjustable Angle One Piece Footplate
NOTE: For this procedure, refer to FIGURE 7.3 on page 54.
NOTE: This procedure is for Terminator Everyday (ED)
wheelchairs Only.
Replacing the Footrest
1.
Loosen, but DO NOT remove the two allen screws that
secure the footrest to the wheelchair frame.
2.
Slide the existing footrest tubes out of the wheelchair
frame and install new footrest by reversing this step.
3.
Position the new footrest to a determined height.
4.
Tighten the two allen screws that secure the footrest to
the wheelchair frame.
5.
Adjust the footplate to the desired position. Refer to
Adjusting Footplate Angle on page 54 and/or Adjusting
Footplate Depth on page 54.
Adjusting Footplate Angle
1.
Loosen, but DO NOT remove the four flat screws and locknuts that secure the footplate to the two footrest tubes.
2.
Position the footplate to the necessary angle to accommodate the user.
3.
Retighten the four flat screws and locknuts.
NOTE: The locknuts should lie in the channel of the footplate half clamp.
Adjusting Footplate Depth
1.
Loosen, but DO NOT remove the four flat screws and locknuts that secure footplate to the footrest tubes.
NOTE: Observe the angle of footplate for reinstallation.
2.
Move the footplate to one of two positions to accommodate the user.
3.
Retighten the four flat screws and locknuts.
NOTE: The settings for positioning the footplates on the half‐clamps may vary for each end user.
NOTE: The locknuts should lie in the channel of the footplate half clamp.
Everyday Series Wheelchairs/Sport Series Wheelchairs
Wheelchair Frame
Half Clamp
Raised
Footrest
FIGURE 7.2 Installing/Adjusting Optional Clamp on
Allen Screws
Height
Depth
FIGURE 7.3 Replacing/Adjusting Optional Adjustable
Angle One Piece Footplate
54
Allen
Screws
Outside
Footrest
Raised Footrest
Footrest
Tube
Angle
Flat Screws
Part No 1122172
Hoop
Flat
Screws
Footpla
Advertisement
Table of Contents
