Table of Contents
Advertisement
Top Adjustment Hole
Anti-Tipper
Ground/
Floor
Installing/Removing/Adjusting Swivel Anti-Tip
NOTE: For this procedure, refer to FIGURE 7.7 on page 58.
NOTE: This applies to any Terminator ordered with swivel anti‐tip.
Installing/Depth Adjustment
1.
Loosen set screws on anti‐tip receivers (FIGURE 7.7).
2.
Slide the swivel anti‐tip into the anti‐tip receivers. Position swivel anti‐tip so it is even with wheels on chair or extends
beyond them. Tighten set screws.
Removing
1.
Loosen set screws on anti‐tip receivers (FIGURE 7.7).
2.
Slide the swivel anti‐tip out of the receivers.
Part No 1122172
PART NUMBER
1112178
DETAIL"A" - ANTI-TIPPER
ADJUSTMENT HOLES
Anti-Tipper Bar
Release Buttons
1-1/2 to 2 inch
(53.66 cm)
Clearance
FIGURE 7.6 Adjusting/Replacing Anti-Tipper
SECTION 7—FOOTREST/ANTI-TIPPER
MEASUREMENT
21 - 1/8-inches
(53.66 cm)
Hole
Camber Clamp
Anti-Tipper
Socket
57
Everyday Series Wheelchairs/Sport Series Wheelchairs
Advertisement
Table of Contents
