Fine Adjustment - Invacare Top End Owner's Operator And Maintenance Manual

SECTION 5—WHEELS
FIGURE 5.11 Adjusting Toe In/Toe Out - Adjustable Camber System - Course Adjustment
NOTE: DO NOT tighten the phillips screw on the other adjustment ring at this time.
NOTE: Repeat STEPS 1‐7 of this procedure for the other adjustment ring after repositioning the camber insert. Refer to Adjusting Rear
Wheel Camber on page 35.
NOTE: When positioning the other adjustment ring, rotate the ring until the stop is at the bottom of the slot in the camber clamp. The
right and left stops MUST be positioned opposite to each other or Fine Adjustment on page 38 will not work correctly.
NOTE: When the left adjustment ring is adjusted to a camber, the right adjustment ring will not touch the camber clamp and when the
right adjustment ring is adjusted to the other camber the left adjustment ring will not touch the camber clamp.

Fine Adjustment

NOTE: For this procedure, refer to FIGURE 5.12 and FIGURE 5.13 on page 39.
NOTE: This adjustment is required anytime the camber insert is repositioned.
1. Open the camber clamp. Refer to Opening/Closing Camber Clamps on page 34.
2. Slowly rotate the axle tube until the stop on the opposite adjustment ring is positioned at the opposite end of the camber
clamp.
3. Close the camber clamp. Refer to Opening/Closing Camber Clamps on page 34.
NOTE: Rear wheels are removed from the drawings for clarity, there is no need to remove rear wheels from the wheelchair during
adjustment.
NOTE: FIGURE 5.13 shows one example of how the adjustment rings can be positioned.
Everyday Series Wheelchairs/Sport Series Wheelchairs
Stop - Not touching
camber clamp
Adjustment Ring
Camber Clamp
Stop - In position for one camber,
touching camber clamp
Adjustment Ring
Axle Tube - Rotates Up and Down
FIGURE 5.12 Adjustable Camber System
Stop - In position for one camber,
touching camber clamp
Adjustment Ring
Camber Clamp
Adjustment Ring
Stop - Not touching
camber clamp
38
Part No 1122172