SECTION 12—ELECTRONICS
Disconnecting/Connecting the MK
Joysticks
5
NOTE: For this procedure, refer to FIGURE 12.2.
Disconnecting
1. Loosen the thumb screws on the joystick connector.
2. Disconnect the joystick connector from the controller connector.
Connecting
1. Align the joystick connector with the controller connector.
2. Secure the joystick connector to the controller connector using the thumb screws on
the controller connector.
WARNING
The excess joystick cable must be coiled, and tie-wrapped to the rear of the seat
frame to ensure that cable does NOT become entangled or damaged during normal
operation of seating system - otherwise injury or damage may result.
3. If necessary, coil and tie wrap excess joystick cable to rear of seat frame.
Light Grey Collar
Joystick
Controller
Connector
Connector
FIGURE 12.2 Disconnecting/Connecting the MK5 Joysticks
Programming the Control Module
Charger/
WARNING
Programming Port
DO NOT attempt to program the con-
trol module. This section MUST be per-
formed by a qualified technician.
NOTE: For this procedure, refer to
FIGURE 12.3.
NOTE: Connect programmer to multi‐
function charger port located on front of
FIGURE 12.3 Programming the Control
joystick as shown in FIGURE 12.3.
Module
69
Part No 1141450
Pronto® M91™ with SureStep®