Invacare Pronto M91 Owner's Manual page 61

DETAIL "A" - BATTERIES WITH
BUILT-IN LIFTING STRAPS
Rear
Battery
Battery
Tray
11. Connect the front battery to the controller (RED connector). Refer to FIGURE 11.2.
12. Connect the rear battery to the front battery (RED and BLACK connectors). Refer to
FIGURE 11.2.
13. Reinstall the top shroud. Refer to Removing/Installing the Shrouds on page 55.
14. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 36.
15. Connect the joystick. Refer to Disconnecting/Connecting the MK5 Joysticks on
page 69.
NOTE: New battery(ies) MUST be fully charged before using, otherwise the life of the battery(ies)
will be reduced.
16. If necessary, charge the battery(ies). Refer to Charging Batteries on page 64.
RED Connector from
Battery to Controller
Front Battery
Tie Wrap
RED Front POSITIVE (+)
Battery Terminal Mounting
Screw, Nut and Fuse Hardware
(Terminal Cap Shown)
RED Battery Connectors
RED Rear POSITIVE (+) Battery
Terminal Mounting Screw, Nut
and Fuse Hardware*
*NOTE: Terminal cap shown removed for clarity.
Part No 1141450
Built-in Lifting
Straps
Front
Battery
FIGURE 11.1 Batteries with/without Lifting straps
Front of Wheelchair
Rear of wheelchair
FIGURE 11.2 Installing/Removing the Batteries
DETAIL "B" - BATTERIES WITHOUT
BUILT-IN LIFTING STRAPS
Battery Lifting Straps
Battery
Terminals/Posts
RED Controller Connector
BLACK Front NEGATIVE (-)
Screw, Nut and Fuse Hardware
Tie Wrap
BLACK Battery Connectors
GREY Rear NEGATIVE (-)
Battery Terminal Mounting
Screw, Nut and Fuse Hardware*
61
Pronto® M91™ with SureStep®
SECTION 11—BATTERIES
Battery
(Not Shown)
Battery Terminal Mounting
(Terminal Cap Shown)
Rear Battery
Retaining Strap