HP NetServer AA 4000 Installation Manual page 64

Completing the Unattended Installation
The procedure you follow to complete the Unattended Installation of the CE software is
dependent upon your specific hardware configuration.
For a KVM Switch
If your configuration contains a keyboard, video, mouse (KVM) switch with a port for each CE
and IOP, follow these steps to complete the Unattended Installation of the CE software:
Step Action
1 Use the KVM switch in order to view the CE1 video.
2 The Windows screen Configure Your Server should
be displayed.
3 Use the KVM switch to change focus to the IOP in
order to view the IOP's video.
4
From the application task bar, select Start
Programs
Endurance Manager to start the Endurance
Manager.
5 Using the Endurance Manager, invoke the
command CE_O/S Shutdown Operation from
IOPx, where x is the ID number of the IOP from
which you issue the command.
6 On the IOP, start the CE Desktop application.
3-26
Marathon Endurance
Notes
Select the port connected to CE1's
keyboard, video, and mouse.
This occurs at the conclusion of step 11
of the previous section, up to one hour
after the start of the CE installation.
Viewing this screen indicates that Setup
has completed on the CE.
Select the port connected to IOP1's
keyboard, video, and mouse.
The CE Endurance System
Management service initiates the
system shutdown.
For information about the CE Desktop
application, refer to Chapter 3
Netserver AA Solution Administrator's
Guide.
Once the CE has rebooted, the video,
keyboard, and mouse are redirected to
the IOP.
HP Netserver AA Solution Installation Guide
of the HP