Verifying Newly Created Npartitions Using The Oa Gui; Removing An Npartition; Removing An Npartition Using The Oa Cli - HP Integrity Superdome 2 16-socket Administrator's Manual

[Blade]
Enclosure/ Usage/
Blade
========== ======================= ========= =============== ==== === ========
1/1
1/2
* D-Deconfigured
[IOBay]
Enclosure/ Usage/
IOBay
========== ======================= === ========
* D-Deconfigured

Verifying newly created nPartitions using the OA GUI

To verify that the partitions are defined as desired, select the nPartition from the Complex nPartitions
table, and then click the Status tab.
Figure 8 nPartition Status Information

Removing an nPartition

This section describes the procedure to remove an nPartition using both the OA interfaces.

Removing an nPartition using the OA CLI

The parremove command removes an existing nPartition by unassigning all blades and I/O bays
from the nPartition. The target nPartition must be inactive unless the -F option is used. By default,
the current partition specification (parspec) associated with the nPartition is not removed when
the nPartition is removed. The current parspec associated with the nPartition becomes an alternate
42 Creating and configuring nPartitions
Status*
Active Base /OK
Active Base /OK
I-Indicted
Status*
I-Indicted
CPU Memory
OK/ (GB)
Indicted/ OK/
Deconf/ Indicted/
Max Deconf
8/0/0/8 128.0/0.0/0.0
8/0/0/8 128.0/0.0/0.0
Par Pending
Num Deletion
Use Par Pending
On Num Deletion
Next
Boot
yes 1 no
yes 1 no