HP Cisco Catalyst Blade Switch 3020 Release Note page 15

CSCtg71149
•
When ports in an EtherChannel are linking up, the message
This condition is often self-correcting, indicated by the appearance of
following the first message. On occasion, the issue does not self-correct, and the ports may remain
unbundled.
The workaround is to reload the switch or to restore the EtherChannel bundle by shutting down and
then enabling the member ports and the EtherChannel in this order:
–
–
–
–
• CSCth44403
When you connect a switch as a VLAN Trunk Protocol (VTP) client to a Catalyst 4000 switch
configured as a VTP client or server and the VTP database contains more than 512 VLANs, the
database is not correctly updated.
The workaround is to connect the VTP client directly to a Catalyst 6500 VTP server.
CSCti27620
•
The switch does not generate SNMP traps when a power supply is disconnected.
There is no workaround.
• CSCti37197
Enabling the Cisco Discovery Protocol (CDP) on a tunnel interface causes the switch to fail when a
a CDP packet is received on the interface.
Note
The workaround is to use the no cdp enable interface configuration command to disable CDP on
the interface.
• CSCti61145
When you configure storm control with range command on two interfaces that belong to an
EtherChannel group, this message appears:
%SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (0/0), process =
Virtual Exec.
The workaround is to configure storm control on a port channel interface.
CSCti69845
•
When MAC Authentication Bypass (MAB) is used in multi-authentication mode, a security
violation occurs after successful authentication.
The workaround is to use a different authentication mode (single, multidomain or multihost).
CSCti78365
•
The config.text.backup file is present after the switch is restored to the factory defaults.
There is no workaround.
OL-24325-01
Enter the shutdown interface configuration command on each member port.
Enter the shutdown command on the port-channel interface.
Enter the no shutdown command on each member port.
Enter the no shutdown command on the port-channel interface.
Tunnels are not supported on these platforms.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(58)SE and Later
Resolved Caveats
might appear.
EC-5-CANNOT_BUNDLE2
EC-5-COMPATIBLE
message
15