Activating An Rrpp Domain - HP 6125G Configuration Manual

To specify an edge node:
Step
1. Enter system view.
2. Enter RRPP domain view.
3. Specify the current device as a master node or
transit node of the primary ring, and specify the
primary port and the secondary port.
4. Specify the current device as the edge node of a
subring, and specify the edge port.
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before configuring
the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
To specify an assistant-edge node:
Step
1. Enter system view.
2. Enter RRPP domain view.
3. Specify the current device as a master node or
transit node of the primary ring, and specify the
primary port and the secondary port.
4. Specify the current device as the assistant-edge
node of the subring, and specify an edge port.

Activating an RRPP domain

To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the RRPP
domain on the current device.
To prevent Hello packets of subrings from being looped on the primary ring, enable the primary ring on
its master node before enabling the subrings on their separate master nodes. On an edge node or
assistant-edge node, enable/disable the primary ring and subrings separately:
Enable the primary ring of an RRPP domain before enabling the subrings of the RRPP domain.
•
• Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
Perform this operation on all nodes in the RRPP domain.
To activate an RRPP domain:
Step
1. Enter system view.
2. Enable RRPP.
Command
system-view
rrpp domain domain-id
ring ring-id node-mode { master | transit }
[ primary-port interface-type interface-number ]
[ secondary-port interface-type interface-number ]
level level-value
ring ring-id node-mode edge [ edge-port
interface-type interface-number ]
Command
system-view
rrpp domain domain-id
ring ring-id node-mode { master | transit }
[ primary-port interface-type interface-number ]
[ secondary-port interface-type interface-number ]
level level-value
ring ring-id node-mode assistant-edge [ edge-port
interface-type interface-number ]
Command
system-view
rrpp enable
60
Remarks
N/A
Disabled by default.