Enabling The Trap Function For Vrrp; Displaying And Maintaining Vrrp For Ipv4 - HP 6125G Configuration Manual

Configuration prerequisites
Before you configure the relevant attributes of VRRP packets, create a VRRP group and configure a virtual
IP address for it.
Configuration procedure
To configure VRRP packet attributes:
Step
1. Enter system view.
2. Set the Differentiated Services
Code Point (DSCP) value for
VRRP packets.
3. Enter the specified interface
view.
4. Configure the authentication
mode and authentication key
when the VRRP groups send
and receive VRRP packets.
5. Configure the time interval for
the master in the VRRP group
to send VRRP advertisements.
6. Disable TTL check on VRRP
packets.

Enabling the trap function for VRRP

When the trap function is enabled for VRRP, VRRP generates traps with severity level errors to report its
key events. The traps are sent to the information center of the device, where you can configure whether
to output the trap information and the output destination. For how to configure the information center, see
Network Management and Monitoring Configuration Guide.
To enable the trap function for VRRP:
Step
1. Enter system view.
2. Enable the trap function for
VRRP.
For more information about the snmp-agent trap enable vrrp command, see the snmp-agent trap enable
command in Network Management and Monitoring Command Reference.

Displaying and maintaining VRRP for IPv4

Command
system-view
vrrp dscp dscp-value
interface interface-type
interface-number
vrrp vrid virtual-router-id
authentication-mode { md5 |
simple } [ cipher ] key
vrrp vrid virtual-router-id timer
advertise adver-interval
vrrp un-check ttl
Command
system-view
snmp-agent trap enable vrrp
[ authfailure | newmaster ]
129
Remarks
N/A
Optional.
48 by default.
N/A
Optional.
Authentication is not performed by
default.
Optional.
1 second by default.
Optional.
Enabled by default.
You do not need to create a VRRP
group before executing this
command.
Remarks
N/A
Optional.
Enabled by default.