HP 6125G Configuration Manual page 160

Member IP
Track Object
Member IP
The output shows that when the timeout timer expires, the VF corresponding to virtual MAC
address 000f-e2ff-0011 is removed, and does not forward the packets destined for the MAC
address any more.
# When Switch A fails, use the display vrrp verbose command to display the detailed information
about VRRP group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Member IP List : 10.1.1.3 (Local, Master)
Forwarder Information: 2 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
The output shows that when Switch A fails, Switch B becomes the master because its priority is
higher than that of Switch C.
# When Switch B fails, use the display vrrp verbose command to display the detailed information
about VRRP group 1 on Switch C.
[SwitchC-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
: 10.1.1.2
: 3 State : Positive
: 10.1.1.3
: Load Balance
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: 10.1.1.1
10.1.1.4 (Backup)
: 255
: Active
: 000f-e2ff-0012 (Owner)
: 0000-5e01-1103
: 255
: local
: Listening
: 000f-e2ff-0013 (Learnt)
: 0000-5e01-1105
: 127
: 10.1.1.4
: 1 State : Positive
: Load Balance
: Virtual MAC
153
: 1
: Master
: 110
: 5
Weight Reduced : 250