Displaying And Maintaining Dldp; Dldp Configuration Examples; Automatically Shutting Down Unidirectional Links - HP 6125G Configuration Manual

Step
2. Reset DLDP state.
Resetting DLDP state in interface view
Resetting DLDP state in interface view applies to the current port.
To reset DLDP state in interface view:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Reset DLDP state.

Displaying and maintaining DLDP

Task
Display the DLDP configuration of
a port.
Display the statistics on DLDP
packets passing through a port.
Clear the statistics on DLDP packets
passing through a port.

DLDP configuration examples

Automatically shutting down unidirectional links

Network requirements
As shown in
•
• Configure DLDP to automatically shut down the faulty port upon detecting a unidirectional link, and
automatically bring up the port after you clear the fault.
Command
system-view
interface interface-type
interface-number
dldp reset
Command
display dldp [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
display dldp statistics [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
reset dldp statistics [ interface-type
interface-number ]
Figure 9, Device A and Device B are connected with two fiber pairs.
Command
dldp reset
39
Remarks
N/A
N/A
N/A
Remarks
Available in any view
Available in any view
Available in user view