Table of Contents
Advertisement
User Manual
2 Open the operation panel by lifting in the middle.
When you hear a soft click, the panel is engaged.
3 Open the scanner cover by pressing the two lugs in.
Th e cover will open downwards.
4 Use a soft cloth to gently wipe the scanner glass on the
top (A) and the white strips on the bottom (B).
5 Close the scanner cover on the left and right, making
sure it clicks into place.
6 Close the panel so that it also clicks into place.
7 Insert paper (see Installation / Loading paper).
48
Cleaning the document feed roller
... when a black stripe appears at the top of a copy.
... when two pages are printed out when copying or send-
ing a single page or when the recipient receives two
pages.
1 Open the machine and the scanner cover by pressing
the latch (A) inward. Clean the feed roller (B) and the
rubber opposing element on the underside (C) with
a soft, lint-free cloth moistened with cleaning alcohol
(96 percent). Turn the feed roller with a slight upward
pressure. You must clean the entire roller.
2 With a Fax-Cleaner: Place the fax cleaner page into
the document feeder and wait until the page is pulled
in. Press STOP. Th e page is ejected. Repeat this proc-
ess at least once.
Troubleshooting
If you cannot fi x the problem based on the instructions
below, you should proceed as follows:
1 Disconnect the mains.
2 Wait at least ten seconds and reconnect.
3 If the fault reoccurs, please contact your customer in-
formation centre. Th e number is on the back of this
manual.
Advertisement
Table of Contents
