When Memory Is Full - Lanier LD 035 Operator's Manual

AdonisC3_GBcopyF_FM1.book Page 82 Thursday, November 28, 2002 1:53 PM
Troubleshooting
Problem
Copies are not in correct or-
der.
❖ ❖ ❖ ❖ Duplex
Problem
3
When using Duplex, copy is
made Top/Bottom even
though Left/Right is selected.
Copies are not in correct or-
der.

When Memory Is Full

Note
❒ If you set [Memory Full Auto Scan Restart] in User Tools (see p.102 "Memory
Full Auto Scan Restart" ) to [Yes], even if the memory becomes full, the mem-
ory overflow message will not be displayed. The machine will make copies of
the scanned originals first, then automatically proceed scanning and copying
the remaining originals. In this case, the resulting sorted pages will not be se-
quential.
Messages
Memory is full. *originals
have been scanned.
Press [Print] to copy scanned
originals.
Do not remove remaining
originals.
Note
❒ Copying will stop and this
message will be displayed
when the memory is full.
Press [Resume] to scan and
copy remaining originals.
[Stop] [Resume]
82
Causes
You placed the originals in
the incorrect order.
Causes
You placed the originals in
the wrong orientation.
You placed the originals in
the incorrect order.
Causes
The scanned original exceeds
the number of pages that can
be stored in memory.
The machine checks if the re-
maining originals should be
copied, after the scanned orig-
inal has been printed.
Solutions
When placing a stack of originals in
the ADF, the last page should be on
the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
Solutions
Place the originals in the correct ori-
entation. See p.10 "Original Orienta-
tion" .
When placing a stack of originals in
the ADF, the last page should be on
the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
Solutions
Press [Output] to copy scanned
originals and cancel the scan-
ning data. Press [Clear] to can-
cel the scanning data and not
copy.
To continue copying, remove
all copies, and then press
[Resume]. To stop copying,
press [Stop].