Setting Up The Hardware - Dell B2375dfw User Manual

Setting up the hardware

This section shows the steps to set up the hardware which is explained in the Placemat.
Make sure you read the Placemat and complete the following steps:
1 Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow extra space to
open covers and trays.
The area should be well-ventilated and away from direct sunlight or sources of heat,
cold, and humidity. Do not set the machine close to the edge of your desk or table.
200 mm
(7.8 inches)
Place the machine on a flat, stable surface so that there is no incline greater than 2
mm (0.08 inch). Otherwise, printing quality may be affected.
2 Unpack the machine and check all the enclosed items.
3 Remove the tape holding the machine tightly.
4
Install the print cartridge.
200 mm
(7.8 inches)
- 33
­