Table of Contents
Advertisement
TROUBLESHOOTING:
In case of power outage, the unit will shut off completely and the synchronization of RF remote
sensors will be lost. You are required to set up the remote sensor & weather forecast again
following the procedures in the manual.
After every battery replacement of the remote sensor, you are required to follow the procedure in
the manual to setup the remote sensor again.
The USB port on the side of the wireless display should not be used as a power source or
charger to provide power to your USB device other than a USB flash drive. The extra power
provided may affect the reception & performance of the wireless display and may reset the unit.
We are not responsible for any damage to the wireless display due to this reason.
If your wireless display does not receive RF temperature & humidity signal from the remote
sensor, check the battery level of the remote sensor. Replace the batteries of the remote sensor
when the "
in the manual. If it continues to fail, try to shorten the distance between the wireless display &
remote sensor and repeat the setup procedure in the manual to link up the sensor. Obstacles or
walls between the remote sensor & wireless display will shorten the effective reception range of
the unit. Do not place the wireless display & remote sensor near metal or electrical appliances
such as TV, computer or Wifi system due to the RF interference emitted from these devices.
Avoid placing the remote sensor in direct sunlight as it will heat up the sensor and provide
inaccurate outdoor temperature reading. In cold weather below 0 C, the battery voltage level of
the remote sensor will drop, the overall transmission range will reduce, and this is normal.
Shorten the distance between the sensor & the wireless display. For extreme low outdoor
temperature below 0C, you are advised to use lithium AAA battery on the remote sensor as
normal alkaline battery may freeze at extreme low temperature.
If the outdoor temperature reading is not changing for several hours, the wireless display has lost
contact with the sensor. The last readings will show until the display is reset.
If your weather forecast reading does not reflect the actual weather condition for a long period,
you are required to adjust the weather forecast setting in the SETUP mode as described in the
manual. Often it is easiest to wait for a rainy day then enter the SETUP menu and select
WEATHER FORECAST then RAINY. Select ENTER and then exit.
If the IR remote control does not function even at a short distance in front of the wireless display,
the battery inside the IR remote control may be flat. Replace a new CR2025 battery following the
battery polarity indicated on the back of the IR remote control.
"low battery icon appears on the sensor's display and repeat the setup procedure
P a g e
| 26
Advertisement
Table of Contents
