Table of Contents
Advertisement
2. ADJUSTING THE HEIGHT OF THE KNEE LIFTER
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
❹
❶
❸
3. INSTALLING THE THREAD STAND
1)
Assemble the thread stand unit, and insert it in the hole in the machine table.
Tighten nut ❶.
2)
For ceiling wiring, pass the power cord through spool rest rod ❷.
3)
The standard height of the presser foot lifted using the
knee lifter is 10 mm.
You can adjust the presser foot lift up to 15 mm using
knee lifter adjust screw ❶.
(Caution)
❷
❷
❶
– 4 –
1. Do not operate the sewing machine in the
state that the presser foot ❸ is lifted by 10
mm or more since the needle bar ❷ comes
in contact with the presser foot ❸.
2. Knee lifter initial position
If the adjustment screw ❹ is over tightened,
the sewing machine will operate in a state
where the presser foot is lifted up, causing
defective sewing or noise.
Advertisement
Table of Contents
