2.
Select ADVANCED > Advanced Setup > Wireless Repeating Function.
3.
Select the Enable Wireless Repeating Function check box.
4.
Select the Wireless Base Station radio button.
5.
To prevent wireless clients from associating with the base station and allowing LAN client
associations only, select the Disable Wireless Client Association check box.
If you prefer wireless clients to be able to associate with the base stations, leave the
check box cleared.
6.
In the Repeater MAC Address 1 through 4 fields, enter the MAC addresses for the access
points that should function as repeaters.
If your router is the base station, it can function as the "parent" for up to four other access
points.
7.
Click the Apply button.
Your changes are saved.
Set Up a Repeater
Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the
wireless connection to the base station.
If you are using the router as the base station with a non-NETGEAR router as the repeater,
you might need to change more configuration settings. In particular, you should disable the
DHCP server function on the access point that is the repeater.
To configure the router as a repeater:
1.
Log in to the router that will be the repeater.
AC1200 WiFi Router JR6100
Advanced Settings
93