NETGEAR AC1200 JR6100 User Manual page 71

2. Select the Port Triggering radio button.
3. Clear the Disable Port Triggering check box.
If the Disable Port Triggering check box is selected after you configure port triggering,
port triggering is disabled. However, any port triggering configuration information that you
specified is saved even though it is not used.
4. In the Port Triggering Timeout field, enter a value up to 9999 minutes.
This value controls the inactivity timer for the designated inbound ports. The inbound
ports close when the inactivity time expires. This is required because the router cannot be
sure when the application has terminated.

To add a port triggering service:
1. On the Port Forwarding/Port Triggering screen, click the Add Service button.
2. In the Service Name field, type a descriptive service name.
3. In the Service User list, select Any, or select Single address and enter the IP address of
one computer.
• Any (the default) allows any computer on the Internet to use this service.
• Single address restricts the service to a particular computer.
4. Select the service type, either TCP or UDP or TCP/UDP (both). If you are not sure, select
TCP/UDP.
5. In the Triggering Port field, enter the number of the outbound traffic port that will cause the
inbound ports to be opened.
6. Enter the inbound connection port information in the Connection Type, Starting Port, and
Ending Port fields.
AC1200 WiFi Router JR6100
Security
71