To Cancel The Timer; Display Messages; Power Outage - GE JTP10GS Use And Care Manual

Built-in electric oven

Hide thumbs

Table Of Contents

Table of Contents

Clock

The clock must be set for the

automatic oven timing functions to

work properly. The time of day

cannot be changed during a Timed

Bake or CLEAN cycle.

Timer

The timer does not

control oven

TIMER

operations. The

ON/OFF

maximum setting on

the timer is 9 hours

and 55 minutes.

To Reset the Timer

If "TIMER" is showing, press the INCREASE or

DECREASE PAD until desired time is reached.

If "TIMER" is not showing, press the TIMER

ON/OFF pad first, then follow instructions above

to set the timer.

End of Cycle Tones

The end of cycle tone is 3 short beeps followed by

1 beep that repeats every 6 seconds until you press

any operation. If you would like to eliminate the

repeating beeps, press and hold the CLEAWOFF pad

for 10 seconds.

To return the end of cycle tone to the repeating beeps,

press and hold the CLEAWOFF pad for 10 seconds.

Power Outage

After a power outage, when power is restored, the display will flash and

time shown will no longer be correct-for example, after a 5-minute power

interruption the clock will be 5 minutes slow. The display flashes until the

clock is reset. All other functions that were in operation when the power

went out will have to be programmed again.

To Set the Clock

Press the

CLOCK pad.

CLOCK

To Set the Timer

Press the TIMER ON/OFF pad.

2. Press the INCREASE or

DECREASE pad to set the

amount of time on timer.

The timer will start automatically

within a few seconds of releasing

the INCREASE or DECREASE pad,

The timer, as you are setting it,

will display seconds until 1 minute

is reached.