To Cancel The Timer; Power Outage - GE JKP17 Use And Care Manual

Jock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
Bake or CLEAN cycle.
Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
Reset the
Timer
-
If "TIMER' is flashing, press the INCREASE or
DECREASE pad until the desired time is reached.
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The end of cycle tone is a series of 3 beeps followed
by I beep every 6 seconds. If you would like to
remove the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for I () seconds.

Power Outage

After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
other functions that were in operation when the
power went out will have to be programmed again.
To Set the Clock
1. Press the
CLOCK pad.
CLOCK
To Set the Timer
1.
Press the TIMER
ON/OFF pad.
TIMER
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.

To Cancel the Timer

Press the TIMER ON/OFF pad while the word
"TIMER" is flashing.
2. Press the
A
INCREASE or
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad to start.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes;
>
"HR ' will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
7