To Cancel The Timer; Power Outage - GE 164D2966P030 Use And Care Manual

Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
Timer
The timer is a minute timer; it does
not control oven operations: The
maximum setting on the timer is 9
hours and 55 minutes.
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until desired time is reached.
If "TIMER" is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The End of Cycle tone is a series of 3 beeps followed by 1 beep every
6 seconds. If you would like to remove the signal that beeps every 6
seconds, press and hold the CLEAIVOFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press and hold the

Power Outage

After a power outage, when power is restored, the display will flash and
time shown will no longer be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the power went out will
have to be programmed again.
To Set the Clock
1. Press the
CLOCK pad.
CLOCK
To Set the Timer
ONIOFF pad.
TIMER
ONIOFF
Press the INCREASE or
2.
DECREASE pad to set the
amount of time on the timer.

To Cancel the Timer

Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.
(continued next page)
2. Press the
A INCREASE or
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad to start.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes.
"HR" will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
7