To Cancel The Timer; Power Outage - GE JTP44 Use And Care Manual

OVEN CONTROL, CLOCK AND TM
be set for the
must
automatic oven timing functions to
work properly. The time of day
Timer
The timer does not control
oven operations. The maximum
setting on the timer is 9 hours and
55 minutes.
DECREASE pad until the desired time is reached.
If "TIMER" is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The End of Cycle tone is a series of 3 beeps followed by I beep every
6 seconds. If you would like to remove the signal that beeps every 6
seconds, press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press and hold the

Power Outage

After a power outage, when power is restored, the display will flash
and time shown will no longer be correct—for example, after a 5-minute
power interruption the clock will be 5 minutes slow.
All other functions that were in operation when the power went out
will have [o be programmed again.
To Set the Clock
1. Press the CLOCK
pad.
CLOCK
To Set the Timer
1. Press the TIMER
ON/OFF pad.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.

To Cancel the Timer

Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.
(( O1lf;/7ilc,(l /1(,.\'l /7(1(s(, )
2. Press the INCREASE
or DECREASE pad
to set the time of day.
Press the CLOCK pad to start.
3.
The timer starts immediately; the
words SET TIME go off after
about one minute.
The timer will display hours and
minutes as it counts down until the
last minute is displayed, then it
displays seconds.
o ~