NETGEAR N600 WNDR3400v3 User Manual page 24

These fields display when your ISP requires a login:
• Internet Service Provider Encapsulation. ISP types. The choices are PPPoE, PPTP, or
L2TP.
• Login. The login name provided by your ISP. The login name is usually an email address.
• Password. The password that you use to log in to your ISP.
• Service Name (If Required). If your ISP provided a service name, enter it here.
Otherwise, you can leave this field blank.
• Connection Mode. This specifies when the router should establish the PPPoE
connection. Currently the connection mode is always on to provide a steady IPv6
connection. The router never disconnects the connection, and in case the connection is
broken (such as if the modem is turned off), the router establishes the connection right
after the PPPoE connection is available.
• Idle Timeout (In minutes). If you want to change the login time-out, enter a new value in
minutes. This value determines how long the router keeps the Internet connection active
after there is no Internet activity from the LAN. Entering a value of 0 (zero) means never
log out.
Internet IP Address.
• Get Dynamically from ISP. Your ISP uses DHCP to assign your IP address. Your ISP
automatically assigns these addresses.
• Use Static IP Address. Enter the IP address, IP subnet mask, and the gateway IP
address that your ISP assigned. The gateway is the ISP router to which your router
connects.
Domain Name Server (DNS) Address. The DNS server is used to look up site addresses
based on their names.
• Get Automatically from ISP. Your ISP uses DHCP to assign your DNS servers. Your ISP
automatically assigns this address.
• Use These DNS Servers. If you know that your ISP does not automatically transmit DNS
addresses to the router during login, select this option, and enter the IP address of your
ISP primary DNS server. If a secondary DNS server address is available, enter it also.
Router MAC Address. The Ethernet MAC address used by the router on the Internet port.
Some ISPs register the MAC address of the network interface card in your computer when
your account is first opened. They accept traffic only from the MAC address of that computer.
This feature allows your router to use your computer's MAC address (this is also called
cloning).
• Use Default Address. Use the default MAC address.
• Use Computer MAC Address. The router captures and uses the MAC address of the
computer that you are now using. You have to use the one computer allowed by the ISP.
• Use This MAC Address. Enter the MAC address that you want to use.
N600 Wireless Dual Band Router WNDR3400v3
genie Basic Settings
24