NETGEAR N300 User Manual page 95

The Port Triggering - Services screen displays:
6. In the Service Name field, type a descriptive service name.
7. In the Service User list, select Any (the default) to allow this service to be used by any
computer on the Internet. Otherwise, select Single address, and enter the IP address of
one computer to restrict the service to a particular computer.
8. In the Service Type list, select the protocol. Select either TCP or UDP.
9. In the Triggering Port field, enter the number of the outbound traffic port that should cause
the inbound ports to be opened.
10. Enter the inbound connection port information in the Connection Type, Starting Port, and
Ending Port fields.
11. Click the Apply button.
The service is added to the Port Triggering Portmap table on the Port Forwarding / Port
Triggering screen. By default, the service is enabled, that is, the Enable check box is
selected.

To edit or delete a port triggering entry:
1. Select Advanced > Advanced Setup > Port Forwarding / Port Triggering.
The Port Forwarding / Port Triggering screen displays.
2. Select the Port Triggering radio button.
The screen adjusts to display the port triggering information.
3. In the Port Triggering Portmap Table, select the radio button next to the service that you
want to edit or delete.
N300 Wireless Router WNR2000v4
Advanced Settings
95