NETGEAR N300 User Manual page 81

The Wireless Access Point screen displays:
2. Select the Enable Access Point Mode check box.
The screen adjusts.
3. Configure the IP address settings for the router:
• Get dynamically from existing router. By default, the Get dynamically from existing
router radio button is selected, enabling the router to receive its IP address and other
IP settings from the other router or gateway in your network.
• Use fixed IP Address. Select the Use fixed IP Address radio button to set up static IP
address settings.
NETGEAR does not recommend this setting.
Note: If the other router or gateway in your network also has wireless
capability, NETGEAR recommends that you use wireless settings on
your router that are different from those on the other router or gateway to
avoid interference. You could also disable the wireless radio on the other
router or gateway and use your router only for wireless client access.
4. Click the Apply button.
Note: When you click the Apply button, the IP address of the router
changes and you are disconnected. To reconnect, close and restart
your web browser, and type http://www.routerlogin.net.
N300 Wireless Router WNR2000v4
Advanced Settings
81