Troubleshoot With The Leds; Power Led Is Off Or Blinking; Leds Never Turn Off - NETGEAR N750 User Manual

• Wired and wirelessly connected computers need to have network (IP) addresses on the
same network as the router. The simplest way to do this is to configure each computer to
obtain an IP address automatically using DHCP.
• Some cable modem service providers require you to use the MAC address of the
computer initially registered on the account. You can view the MAC address in the
Attached Devices screen.

Troubleshoot with the LEDs

After you turn on power to the router, the following sequence of events should occur:
1. When power is first applied, verify that the Power LED
2. After 2 minutes, verify the following:
• The Power LED lights solid green.
• The Internet LED lights.
• The 2.4 GHz and 5 GHz LEDs light.
The LEDs on the front panel of the router can be used for troubleshooting.

Power LED Is Off or Blinking

• Make sure that the power cord is securely connected to your router and that the power
adapter is securely connected to a functioning power outlet.
• Check that you are using the 12V DC, 5A power adapter that NETGEAR supplied for this
product.
• If the Power LED blinks slowly and continuously, the router firmware is corrupted. This can
happen if a firmware upgrade is interrupted, or if the router detects a problem with the
firmware. If the error persists, you have a hardware problem. For recovery instructions, or
help with a hardware problem, contact technical support at

LEDs Never Turn Off

When the router is turned on, the LEDs light for about 10 seconds and then turn off. If all the
LEDs stay on, there is a fault within the router.
If all LEDs are still lit 1 minute after power-up:
• Cycle the power to see if the router recovers.
• Press and hold the Restore Factory Settings button to return the router to its factory
settings as explained in
If the error persists, you might have a hardware problem and should contact technical
support at www.netgear.com/support.
N750 Wireless Dual Band Gigabit Router WNDR4300
Factory Settings
Troubleshooting
lights.
www.netgear.com/support.
on page 123.
117