Ford Windstar Owner's Manual page 61

Using the "SCAN" function with your cassette tape player
Press the "SCAN/TUNE" button to enter the scan mode
(display indicates "SCN"). Pushing the right a side of the
"SEEK" button will begin the forward scan mode on the tape
currently playing, stopping on each tape selection for
approximately an eight-second sampling.
Pushing the left b side of the "SEEK" button will begin the
reverse scan mode, stopping on each previous tape selection
for approximately an eight-second sampling. While scanning,
the display indicates whirling sprockets plus an "S" m.
To stop the scan mode on the presently sampled tape
selection, press the "SCAN/TUNE" button again.
How to eject the tape
To stop the tape and eject the cassette, press the "EJCT" button.
The radio will resume playing if the radio power is on. The
tape cartridge can be ejected with radio power (and/or ignition)
on or off.
How to store the tape
Press the "AM/FM" button to stop the tape player and resume
radio play. The cassette will be stored in the tape player and
the X symbol in the display will be lit until you push the
"PLAY PROG" button to resume tape play. Fast forward and
fast rewind can be used while the tape is in storage mode
without interrupting radio play.
Using the Dolby B noise reduction feature
Dolby is a Registered Trademark of Dolby Laboratories
Licensing Corp.
Push the k button to activate. When on, the k symbol
above the button will be lit.
60