Ford Windstar Owner's Manual page 115

To Cancel or Turn Off Speed Control
The speed control can be cancelled at any time by depressing
the brake pedal slightly. After cancelling, you can return to the
speed you set by pressing the RESUME switch, or set a new
speed by pressing the SET ACCEL or COAST switch.
Speed control can also be cancelled when you press the OFF
switch. The speed control system will remain off until you press
the ON switch and reset the speed control.
In addition, the speed control is turned off each time you turn
the vehicle ignition off.
Cancelling and Resuming a Set Speed
If you press the brake pedal, the speed control is cancelled. You
can return to the speed you set by using the RSM switch, as
long as you did not press the OFF switch.
To resume the speed you had before, you must be driving at
least 30 mph (50 km/h).
Press and release the RESUME switch. Your vehicle gradually
returns to the previously set speed and then maintains it.
Speed Control Light (Electronic Cluster Only)
This light comes on when you turn on the speed control system
and set the speed. The light will be on whenever the speed
control is set, even if you override the set speed by pressing the
accelerator pedal or by pressing the coast button. The light will
go off when the brakes are used or the speed control system is
turned off.
This light comes on briefly during the display self-test every
time you turn your ignition key to the ON position. The light
will go off when the key is turned to the START position. The
light should stay off when the self-test is done.
114