Ford Windstar Owner's Manual page 57

Setting the station MEMORY PRESET buttons
Your radio is equipped with 5 station memory buttons.
These buttons can be used to select up to 5 preset AM
stations and 10 preset FM stations (5 in FM1 and 5 in FM2).
Follow the easy steps below to set these buttons to the desired
frequencies:
Select a band, then select a frequency.
1.
Press one of the memory preset buttons and hold the button
2.
until the sound returns. That station is now held in memory
on that button.
Follow the two steps above for each station memory preset
3.
button you want to set.
Using the Automatic Memory Load feature
NOTE: If no stations are in memory presets, you can activate
the feature by pressing and holding the "AUTO
PRESET" button for approximately three seconds.
Auto Memory Load sets all memory buttons in AM,
FM1 and FM2 sequentially by seeking out the first
five strong stations for the respective band and storing
them in memory buttons 1-5. (FM2 will store the
second set of strong stations from the FM band.)
With Auto Memory Store, you can continually set strong
stations into your memory buttons without losing your existing
memory presets, which is especially helpful while traveling.
Your radio will automatically set your memory buttons to the
strong local stations so you don't have to continually manually
tune to existing stations.
Activate Auto Memory Store by pushing the "AUTO PRESET"
button once. Your radio will set the first five strong stations of
the band you are in (AM, FM1 or FM2) into the memory
buttons. The display will show "AUTO", then run through the
56