Ford Windstar Owner's Manual page 56

Electronic Sound Systems
Using the "TUNE" function
You can change the frequency up or down one increment at
a time (FM changes in increments of 200 kHz; AM changes
in increments of 10 kHz) by first pressing the
"SCAN/TUNE" button twice (display shows "TUNE"), then
— within approximately five seconds —pressing and
releasing either the right a or left b side of the "SEEK"
button. To change frequencies quickly, press and hold down
either the right or left side of the "SEEK" button.
Manual tuning adjusts your radio to any allowable broadcast
frequency, whether or not a station is present on that
frequency. (See All About Radio Frequencies in this section.)
Using the "SEEK" function
This feature on your radio allows you to automatically select
listenable stations up or down the frequency band. Press the
right a side of the "SEEK" button to select the next
listenable station up the frequency band. Press the left b
side of the button to select the next listenable station down
the frequency band. By holding the button down, listenable
stations can be passed over to reach the desired station.
Using the "SCAN" function
Pressing the "SCAN/TUNE" button once enters the scan
mode (display will indicate "SCN"). Pushing the right a
side of the "SEEK" button will begin the scan mode up the
frequency band, stopping on each listenable station for
approximately a five-second sampling. Pushing the left b
side of the "SEEK" button will begin the scan mode down
the frequency band, again stopping on each listenable station
for approximately a five-second sampling.
To stop the scan mode on the presently sampled station,
press the "SCAN/TUNE" button again.
55