Displaying And Maintaining Habp; Habp Configuration Example - 3Com 4500G Family Configuration Manual

Follow these steps to configure an HABP client:
To do...
Enter system view
Enable HABP
Configure HABP to work in client
mode

Displaying and Maintaining HABP

To do...
Display HABP configuration
information
Display HABP MAC address table
entries
Display HABP packet statistics

HABP Configuration Example

Network requirements
As shown in Figure
authentication is configured on Switch A for central authentication and management of users (Host A
through Host D). In this case,
For communication between Switch B and Switch C, you need to enable HABP server on Switch A
and enable HABP client on Switch B and Switch C.
On Switch A, set the interval to send HABP request packets to 50 seconds.
Use the command...
system-view
habp enable
undo habp server
Use the command...
display habp
display habp table
display habp traffic
1-2, Switch A is attached with access devices Switch B and Switch C. 802.1X
—
Optional
Enabled by default
Optional
HABP works in client mode by default.
Available in any view
Available in any view
Available in any view
1-3
Remarks
Remarks