Defining Apply Clauses - 3Com 4500G Family Configuration Manual

To do...
Match IPv4 routing
information whose next
hop or source is
specified in the ACL or
IP prefix list
Match IPv6 routing information
whose next hop or source is
specified in the ACL or IP prefix list
Match routes having the specified
cost
Match routing information having
specified outbound interface(s)
Match RIP routing information
having the specified tag value
The if-match clauses of a route policy node are in logic AND relationship, namely, routing
information has to satisfy all its if-match clauses before being executed with its apply clauses.
You can specify no or multiple if-match clauses for a route policy node. If no if-match clause is
specified, and the route policy node is in permit mode, all routing information can pass the node. If
it is in deny mode, no routing information can pass it.
The if-match commands for matching IPv4 destination, next hop and source address are different
from those for matching IPv6 ones.

Defining apply Clauses

Follow these steps to define apply clauses for a route policy:
To do...
Enter system view
Enter route policy node view
Use the command...
if-match ip { next-hop |
route-source } { acl
acl-number | ip-prefix
ip-prefix-name }
if-match ipv6 { address |
next-hop | route-source } { acl
acl-number | prefix-list
ipv6-prefix-name }
if-match cost value
if-match interface
{ interface-type
interface-number }&<1-16>
if-match tag value
Use the command...
system-view
route-policy
route-policy-name { permit
| deny } node node-number
1-6
Remarks
Optional
Not configured by default.
Optional
Not configured by default.
Optional
Not configured by default.
Optional
Not configured by default.
Optional
Not configured by default.
Remarks
—
Required
Not created by default.