Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual page 61

Chapter 5 Connecting the Router to Power
Figure 5-5
Item
1
2
OL-26438-02
Router Power and Reset Buttons
1
PE N L3 L2
Button Description
CONFIG Reset Press the CONFIG Reset button for at least 5 seconds to return the router
software configuration to the factory default, and power cycle the router.
Power cycling the router turns the router off, then immediately back on. The
router will temporarily stop operating on the network during the power
cycle, then resume operating when the power cycle process is complete.
PWR RESET Press the PWR RESET button for at least 5 seconds to power cycle the
router. Power cycling the router turns the router off, then immediately back
on. The router will temporarily stop operating on the network during the
power cycle, then resume operating when power cycle process is complete.
L1
Cisco 1120 Connected Grid Router Hardware Installation Guide
Power Cycling the Router
2
-
+
5-11