Appendix B
Connector and Cable Specifications
Table B-6
SFP Module
1000BASE-LX/LH 1310
1000BASE-EX
1000BASE-ZX
1000BASE-BX-U
1000BASE-BS-D
1. A mode-conditioning patch cord is required. Using an ordinary patch cord with MMF or 1000BASE-LX/LH SFP modules
and a short link distance can cause transceiver saturation and an elevated bit error rate (BER). When using the LX/LH SFP
module with 62.5-micron diameter MMF, you must also install a mode-conditioning patch cord between the SFP module and
the MMF cable on both the sending and receiving ends of the link. The mode-conditioning patch cord is required for link
distances greater than 984 feet (300 m).
2. 1000BASE-ZX SFP modules can send data up to 62 miles (100 km) by using dispersion-shifted SMF or low-attenuation SMF;
the distance depends on the fiber quality, the number of splices, and the connectors.
OL-26438-02
SFP Port Cabling Specification (continued)
Wavelength
Cable
(nm)
Type
MMF
SMF
1310
SMF
1550
SMF
1310
SMF
1490
SMF
Cisco 1120 Connected Grid Router Hardware Installation Guide
Core size/
Modal
Cladding Size
Bandwidth
(micron)
(MHz/km)
1
62.5/125
500
50/125
400
50/125
500
G.6522
—
—
—
2
G.652
—
—
—
—
—
Cable and Adapter Specifications
Cable Distance
1804 feet (550 m)
1804 feet (550 m)
1804 feet (550 m)
32,808 feet (10,000 km)
131,234 feet (40,000 km)
43.4 to 62 miles
2
(70 to 100 km)
32,808 ft (10,000 m)
32,808 ft (10,000 m)
B-5