Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual page 58

Connect to AC Power
To connect the router to AC power, follow these steps:
The router will power on as soon as it is connected to an AC power source. You are not required to press
Note
a power button to power on the router.
When connecting the router AC power connector, always connect the router end of the cable first. When
Caution
removing the AC power connector, always disconnect the router end of the cable last.
Step 1 Turn off power to the AC power source at the designated circuits.
Use a wire-stripping tool to strip each of the wires from the AC-input power source. Expose the wire to
Step 2
the appropriate length for the terminal block, about 0.25 inches.
Insert the wires into the terminal block openings that correspond to the labeled AC terminals shown in
Step 3
Figure 5-1
Insert wires that correspond to your installation (three-phase or single-phase), as shown here:
1
After the wires are inserted in the terminal block, use the screwdriver to tighten the terminal block wire
Step 4
screws to keep the wires in place. The screws are shown in
Taking care not to place strain on the wires, insert the terminal block into the mating connector on the
Step 5
router. The mating connector is shown in
Use the screwdriver to tighten the two captive screws on the terminal block to the mating connector. The
Step 6
terminal screws are shown in
Turn on AC power by plugging in an AC power cord to the power source, or enabling power at the
Step 7
designated circuit. The router will power on and run a series of bootup tests, indicated by blinking LEDs.
Cisco 1120 Connected Grid Router Hardware Installation Guide
5-8
and described in Table 5-1.
2 3 4 5
3-Phase AC Power
Figure
1
Single-Phase AC Power
Figure
Figure 5-4.
5-2. Torque the terminal block screws to 11 lbf-in.
Chapter 5 Connecting the Router to Power
2 3
5-2.
OL-26438-02