Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual page 11

Installation Safety and Site Preparation
This document provides information you should be aware of before installing the Cisco 1120
Connected Grid Router, such as safety information, installation recommendations, and site
requirements.
This chapter contains the following sections:
Safety Recommendations, page 2-2
•
General Site Requirements, page 2-4
•
Rack Mounting, page 2-4
•
Router Environmental Requirements, page 2-4
•
Power Guidelines and Requirements, page 2-4
•
• Network Cabling Specifications, page 2-5
Required Tools and Equipment for Installation and Maintenance, page 2-7
•
To see translated warnings that appear in this publication, see the Regulatory Compliance and Safety
Note
Information document that came with the router.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than: Maximum 15 A, 120 Vac or Maximum 10 A, 230 Vac
Statement 1005
OL-26438-02
C H A P T E R
Cisco 1120 Connected Grid Router Hardware Installation Guide
2
2-1