Chapter 4
Mounting the Router
Figure 4-7
To ground the router, follow these steps:
Use the appropriate crimping tool or pliers to crimp a 6-gauge ground that will attach to the grounding
Step 1
lug on the router exterior. You must provide the wire.
Figure 4-6
Connect the other end of the wire to the router grounding connectors, using the supplied grounding
Step 2
screws. Tighten the grounding screws to 10 to 12 foot-pounds of torque. Do not overtighten!
If necessary, strip the other end of the ground wire and connect it to a reliable earth ground, such as a
Step 3
grounding rod or an appropriate grounding point on substation equipment that is grounded.
OL-26438-02
Router Grounding Lug Location
shows the grounding lug location.
Cisco 1120 Connected Grid Router Hardware Installation Guide
Ground the Router
4-9