Cisco ASR 5000 Application Detection and Control Administration Guide Hardware Installation Manual page 45

Chapter 4 Mounting the Router
Step 4 Place the mounting bracket onto the back of the router, following these guidelines, shown in
The bracket handle (Item 3,
•
Align the bracket mounting holes (Item 2,
•
Figure
Figure 4-3
1
Replace the screws you removed in
Step 5
Evenly hand-tighten the screws (Item 1 in
Step 6
OL-26438-02
Figure 4-3
4-3). (The screws were removed from the bracket connectors in
Align the Bracket Mounting Holes (2) over the Router Bracket Connectors (3)
2
3
Step 2
) should be facing the router cable panel.
Figure 4-3) with the router bracket connectors (Item 1,
to secure the mounting bracket to the chassis.
Figure 4-4), then tighten with the Phillips #2 screwdriver.
Cisco 1120 Connected Grid Router Hardware Installation Guide
Mounting Instructions
Figure 4-3:
Step 2.)
4-5