Ford Super Duty Owner's Manual page 175

Hide thumbs Also See for Super Duty:

Table of Contents

174 Universal Garage Door Opener (If Equipped)

Erasing the Function Button Codes

Reprogramming a single button

To program a device to a previously trained button, follow these steps:

1. Press and hold the desired button. Do NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without

releasing the button, follow Step 1 in the Programming section.

For questions or comments, contact HomeLink® at www.homelink.com

or 1-800-355-3515.

Programming HomeLink® to a Genie Intellicode® 2 garage door

Note: The Genie Intellicode® 2 transmitter must already be

programmed to operate with the garage door opener.

Programing the transmitters

To program HomeLink® to the transmitter you must first put the

transmitter into programming mode. To do this

1. Press and hold one of the buttons on the hand-held transmitter for

10 seconds. The LED light will change from green to green and red.

2013 F-250/350/450/550 (f23)

Owners Guide gf, 1st Printing

Note: You cannot erase individual

1. Press and hold the outer two

function buttons simultaneously for

approximately 20 seconds until the

indicator lights above the buttons

flash rapidly.

2. When the indicator lights flash,

release the buttons. The codes for

all buttons are erased.

B. Green LED