Configuration Parameters - GE EPM 5300 Instruction Manual

16.7: Configuration Parameters

After entering Setup Mode (confirm by pressing Enter), you an configure the parameters by entering one
of the numbers on the Change Setup Menu, or you can confirm default values by pressing Enter. Be
sure to store new configurations when you are finished. The Ethernet Interface will then perform a power
reset.
Serial Number 5415404 MAC Address 00:20:4A:54:3C:2C
Software Version V01.2 (000719)
Press Enter to go into Setup Mode
1) Network/IP Settings:
Ethernet Interface Autodetect
IP Address
Default Gateway
Netmask
2) Serial & Mode Settings:
Protocol
Serial Interface
3) Modem Control Settings:
DCD Output
CTS Output
4) Advanced Modbus Protocol Settings:
Slave Addr/Unit Id Source
Modbus Serial Broadcasts
Character, Message Timeout
D) default settings, S) save, Q) quit without save;
select command or parameter set (1..4) to change: I
BAUD RATE
The Ethernet Interface and attached serial device (the meter) must agree on a speed or baud rate used
for the serial connection. Valid baud rates are 1200, 2400, 4800 and 9600 (default). For the EPM 5350P,
default settings are 9600 baud rate, 8 data, 1 stop, no parity, Modbus RTU.
GE Multilin
- 0.0.0.0/DHCP (Customer Configurable)
--- not set ---
--- not set ---
Modbus/RTU, Slave(s) attached (FIXED)
9600,8,N,1,RS232,DB25 (must match meter) (FIXED)
Fixed High/Active
Fixed High Active
Modbus/TCP header (FIXED)
Disabled
00010 ms, 00500 ms
EPM 5000 series Advanced Power Meters
CHAPTER 16: ETHERNET OPTION
(Customer Configurable)
(Customer Configurable)
95