Bosch VideoJet 8008 Installation And Operating Manual page 142

EN | 142
Malfunction
No connection
established, no
image transmission.
No audio
transmission to
remote station.
The unit does not
report an alarm.
Control of cameras
or other units is not
possible.
The unit is not
operational after a
firmware upload.
Appendix
Installation and Operating Manual | VideoJet 8008 / VideoJet 8004
Possible causes
The unit's configuration.
Faulty installation.
Wrong IP address.
Faulty data transmission
within the LAN.
The maximum number of
connections has been
reached.
Hardware fault.
Faulty cable connections.
Incorrect configuration.
Audio voice connection is
already in use by another
receiver.
Alarm source is not selected. Select possible alarm sources on
No alarm response
specified.
The cable connection
between the serial interface
and the connected unit is not
correct.
The interface parameters do
not match those of the other
unit connected.
Power failure during
programming by the update
file.
Incorrect update file.
Solution
Check all configuration
parameters.
Check all cables, plugs, contacts
and connections.
Check the IP addresses (terminal
program).
Check the data transmission with
ping
.
Wait until there is a free connection
and then call the sender again.
Check that all connected audio
units are operating correctly.
Check all cables, plugs, contacts
and connections.
Check the configuration of the
audio settings (gain and
activation).
Wait until the connection is free and
then call the sender again.
the Alarm sources configuration
page.
Specify the desired alarm response
on the Alarm connections
configuration page, change the
IP address if necessary.
Check all cable connections and
ensure all plugs are properly fitted.
Make sure that the settings of all
units involved are compatible.
Have the unit checked by
Customer Service and replace if
necessary.
Enter the unit's IP address followed
by /main.htm in the Web browser
and repeat the upload.
Bosch Security Systems | 2006-07 | V1.5